Search for the product you are looking for
Vehicle Testing Laboratory

Vehicle Testing Laboratory

Product Introduction
Vehicle Testing Laboratory is a necessary testing equipment in the automotive field, used to test and determine the electrical, electronic and other products and materials for high temperature, low temperature, alternating humidity and heat or temperature and humidity after the constant test of product parameters and performance.

Service Hotline

4000-662-888
Product Features
Product Parameter
Model Studio Size(D*W*H)mm Dimension(D*W*H)mm
LRHS-170M3-LJS 10000×4880×3500 10400×5730×4230
Temperature range -40℃~+45℃
Temperature fluctuation ≤±1°C
Temperature uniformity ≤±2°C
Heating rate -40℃~+25℃,average rate 0.27℃/min
Cooling rate +25℃~-40℃,average rate 0.27℃/min
Humidity range 40%~85%RH
Outer box material High-quality cold-rolled steel plate, surface plastic spraying treatment
Inside box material Stainless steel plate SUS304
Insulation material Rigid polyurethane foam + glass fiber
Controller Adopting Japan “UMC” brand temperature meter
Cooling method Twin-combined refrigeration
Temperature and Humidity Sensor High Accuracy Pt100 Platinum Resistance Temperature Sensors
Internal fan 35mph±10%Speed of wind through the interior of the test chamber
Safety protection Compressor low pressure/overload/high pressure alarm, fan motor overload, overall equipment timing, short circuit, phase loss, over temperature, leakage and other protection
Supply Voltage AC380V±10% 50Hz
Cooling method Water Cold

 

Product Recommendation
Industry News
In the daily use of the constant temperature and humidity test chamber, due to operational errors or a lack of regular maintenance, the equipment may occasionally experience faults, thereby disrupting the normal workflow.
Conducting salt spray tests in natural environments through exposure is not only time-consuming but also yields results that are often inconsistent and difficult to control.
Walk-in dust and sand test chambers are designed to simulate natural sandstorm conditions to test the protective performance of large equipment, while IP56X dust and sand chambers focus on shell sealing detection and are suitable for small and medium-sized electronic and electrical products.
Telegram WhatsApp Facebook VK LinkedIn