Search for the product you are looking for
Mold Test Chamber

Mold Test Chamber

Product Introduction
Mold test chamber is colleges and universities, medicine, military, electronics, chemical industry, biological research departments for the storage of strains, biological culture and scientific research experiments necessary test equipment. It is used to test and judge its parameters and performance after the change of hot and humid temperature environment.

Service Hotline

4000-662-888
Product Features
Product Parameter
Model Studio Size  (D*W*H)mm Dimension(D*W*H)mm
LRHS-101-MJ 450×450×500 1080×960×1630
LRHS-225-MJ 500×600×750 1130×1110×1880
LRHS-504-MJ 700×800×900 1180×1310×2065
LRHS-800-MJ 800×1000×1000 1280×1510×2180
LRHS-1000-MJ 1000×1000×1000 1480×1510×2180
temperature range 20℃~45℃
Temperature uniformity ≤2℃(at no load)
Temperature fluctuation ±0.5℃(at no load)
Time Setting Range 1~60000M
Humidity range 80%~98%RH
Humidity uniformity +2% -3% RH
Humidity fluctuations ±2%
heating rate 1.0~3.0℃/min
cooling rate 0.7~1.0℃/min
wind speed ≤1m/s
Optimal growing environment Temperature: 25℃~29℃ Humidity: 95%
viewing window 210 x 275mm or 395 x 395mm (effective field of view)
Outer case material High quality A3 steel plate electrostatic spraying
Inner box material High quality stainless steel SUS304
Insulation material Rigid polyurethane foam + fiberglass
Temperature and humidity controller Imported “UEC” brand temperature and humidity meter
Temperature and humidity sensors PT100 platinum resistance temperature measurement body
refrigeration system stand-alone refrigeration
Compressor Taikang, France
standard configuration 1 roll of wet bulb gauze, 2 sample racks, with condensate catch pan and drain out of the box
security protection Compressor overpressure overload, over temperature, fan motor overheating, leakage protection
Whole machine under phase/reverse phase, whole equipment timing, overload and short-circuit protection
Supply Voltage AC220V±10% 50Hz
Power 4.0kW/5.5kW/6.5kW/8.5kW/9.5kW
operating environment 5℃~+35℃ ≤85% RH
Note:
1、the above data are in the use of ambient temperature of 25 ℃ and well-ventilated conditions measured
2、Can be customized according to the specific requirements of the user non-standard mold test chamber etc
3、This technical information, subject to change without notice

 

Product Recommendation
Industry News
A salt spray test chamber is an accelerated corrosion environmental testing device. The primary causes of metal corrosion include oxygen, salt particles, pollutants in the air, as well as changes in temperature and humidity.
Cold and thermal shock test chamber on the market is divided into two categories, a two-compartment type, including high-temperature region and low-temperature region, the test object were in two different temperatures in the area of the test, hot and cold alternating test; the other is a three-compartment type, in addition to high-temperature and low-temperature areas, there is also a test area, and the two-compartment different is that the three-compartment does not need to be directly in the test area for the test, only need to be through the air compression method
You may have heard the recommendation that "a temperature & humidity test chamber should use purified water." But why is that? Can other types of water not be used?