Search for the product you are looking for
UV Aging Simulation Test Chamber

UV Aging Simulation Test Chamber

Product Introduction
Uv aging simulation test chamber is mainly used with the photovoltaic industry, ground with crystalline silicon photovoltaic modules, ground with thin film photovoltaic modules and a series of photovoltaic modules for high temperature, low temperature, alternating humidity and heat degree or constant test of the temperature environment after the change of parameters and performance; or constant humidity and heat test of the temperature environment after the change of parameters and performance. It is specially customized according to the IEC standard, applicable to schools, factories, military industry, scientific research and other units.

Service Hotline

4000-662-888
Product Features
Product Parameter
Model Studio Size  (D*W*H)mm Dimension(D*W*H)mm
LRHS-672-NGF 700×800×1200 1030×1580×2150
light source drive EPS
Effective irradiance area 800mm×700mm
Distance of light source from test surface 1000±200mm
Light source power 2000W/lamp
Number of light sources 1PCS
Light intensity range 150~250W/m2
spectral range 280~320nm 320~400nm
UVB/(UVA+UVB) 5 to 8%
inhomogeneity ≤10%
UVC Content (Ratio of integrated irradiance in the wavelength range (250-280) nm to integrated irradiance in the wavelength range (250-400) nm of UVC content ≤1%.
Sample temperature range 60~70℃ (customized water-cooled structure for cell carrier table)
Sample temperature deviation ≤±2℃
Chamber temperature range 20~80℃
Box temperature fluctuation ≤1℃
Outer case material 1.2mm Cold rolled steel plate with plastic spraying on both sides
Inner box material 1.0mm thick SUS304 stainless steel, sunlight simulating fully reflective reflective film mounted on the side wall for secondary sealing and optical reflection control.
Insulation material 10mm Thickness High Quality Insulation Material
Controller Siemens PLC Module + Touch Screen
Cooling method Air-cooled refrigeration
Compressor Taikang, France
Heating method Nickel-chromium alloy electric wire type heater
light source Holler lamp, metal halide wick, European brand.
Warranty time of the light source 2000 hours, the actual use of time greater than or equal to 3000 hours
irradiance meter Alberdi Brands
security protection Emergency stop button, sample surface temperature is too high, light source system fault alarm, power supply phase/undervoltage/overvoltage/leakage protection, fan overload, compressor overvoltage/overheat/overcurrent, heating wire over-temperature protection
Supply Voltage Voltage: 3/N/PE AC 400V±10% 50Hz Rated current: 30A
Power 20.0kW
operating environment 10℃~+35℃      ≤75% RH
Note:
1、 the above data are measured in the use of ambient temperature of 25 ℃ and well-ventilated conditions
2、Can be customized according to the specific requirements of the user non-standard uv aging simulation test chamber etc
3、This technical information is subject to change without prior notice.
Product Recommendation
Industry News
The UV aging test chamber is a device that simulates ultraviolet radiation and condensation climate environments by using fluorescent ultraviolet lamps as the light source.
The non-uniform distribution of temperature and humidity in a constant temperature and humidity test chamber can affect the final results and lead to errors.
Cold and hot shock test chambers utilize high-temperature and low-temperature zones during testing. In the testing process, two-box models involve placing the test product in high and low-temperature zones for cyclic exposure, while three-box models involve blowing high- and low-temperature gases onto the product alternately.