Walk-in Condensation Test Chamber-Linpin Instruments

Product Parameter

Model	Studio Size (DWH)mm	Dimension（DWH）mm
LRHS-2000-LN	1000×2000×1000	Subject to contractual three-view
LRHS-4000-LN	2000×2000×1000
LRHS-6000-LN	2000×3000×1000
LRHS-8000-LN	2000×2000×2000

temperature range	25℃～45℃
Humidity range	100% RH
Humidity Deviation	+2、-3% RH
heating rate	The air temperature inside the box reaches 40℃ for less than 90 minutes.
Time Setting Range	1～60000M
User Environmental Requirements	Ambient temperature should be controlled at 23±5℃, humidity ≤75%RH or less
viewing window	395×395mm(Effective vision)
Outer case material	High quality A3 steel plate electrostatic spraying
Inner box material	Imported high-grade stainless steel SUS304
Insulation material	Rigid polyurethane foam + fiberglass
Temperature Controller	Imported “UEC” brand temperature and humidity meter
overtemperature protector	Korea RAINBOW
temperature sensor	PT100 platinum resistance temperature measurement body
security protection		Over-temperature, fan motor overheating, overall equipment phase failure/reverse phase Test timing, leakage protection, water shortage and short circuit protection
Supply Voltage		AC380V±10% 50±0.5Hz
Power		7.5kW/11.0kW/15.0kW/20.0kW
Note: 1、the test data are used in the ambient temperature of 25 ℃ and well ventilated conditions measured 2、Can be customized according to the specific requirements of the user non-standard walk-in condensation test chamber etc 3、This technical information, subject to change without notice

Industry News

How to test the waterproofness of the rain test chamber

Rain test chamber is a test instrument to test whether the waterproof is good, the figure of this equipment can be said to be everywhere, applied in various places. Small to our usual use of cell phones, flashlights and other lighting apparatus; large to the aerospace industry, lighting systems, signaling device testing and so on. Waterproof has always been a lot of industry can not get around a topic, a lot of equipment once the rain and other wet, its service life will be greatly reduced, this equipment in the waterproof performance test link plays a vital role.

How to Solve the Tricky Problems of High and Low Temperature Alternating Humidity and Heat Test Chambers

The high and low temperature alternating humidity and heat test chamber is a composite type of test chamber.

How to Detect Leaks in a Temperature Cycling Test Chamber

Previously, we have discussed many technical aspects of temperature cycling test chambers. Today, we will share methods for detecting leaks in these chambers. Specifically, there are four main approaches to check for leaks.