Pendulum Tube Rain Test Device-Linpin Instruments

Product Parameter

Pseudolaric acid		Pendulum tube rain test device
waterproof rating		IPX3、IPX4

Oscillating tube water jet aperture	ø0.4mm
Pendulum Angle Amplitude	±45°、60°、135°、150°、175°(theoretical values)
radius of the pendulum	R=200mm、400mm、600mm、800mm(either one or the other)
Pendulum speed	25°～45°/s
drenching pressure	80～100(Adjustable)
water flow	0.07L/min per hole (±5%)
Spraying water	Clean, soft tap water
Test bench size	ø600mm
Rotational speed of test bench	1-3r/min(Adjustable)
Time Setting Range	1～9999H
Temperature Controller	“Taiwan Weilun” touch screen + ‘Germany Siemens’ PLC module
water pump	Provision of a pressurized test water source
Table rotation	The motor drives the turbine to decelerate and rotate to achieve the effect of low speed and high torque
Nozzle	The nozzle is a detachable special nozzle
security protection		Fan motor overheating, overall equipment under phase/reverse phase Integral equipment timing, leakage protection, overload and short circuit protection
Supply Voltage		AC220V±10% 50Hz
Note: 1、according to the user’s specific requirements of non-standard pendulum tube rain test device etc. 2、This technical information, if there is any change without prior notice

Industry News

Reminder: Anti-Corrosion Measures for Temperature Cycling Test Chambers

Most temperature cycling test chambers on the market feature an inner chamber made of stainless steel. However, after prolonged use, rust may still appear on the equipment. Why does this happen, and are there effective ways to prevent it?

How to Set the Test Temperature for a Super Low Temperature Test Chamber

A super low temperature test chamber is a device used to simulate the performance and reliability of products under low-temperature conditions.

Introduction to the Location and Quantity of Test Points in Low-Temperature Test Chambers

A low-temperature test chamber can accommodate multiple test specimens, but are there specific requirements regarding the location and quantity of test points? Today, we will introduce the guidelines for test point placement and quantity in such equipment.