Flush Test Device-Linpin Instruments

Product Parameter

Pseudolaric acid		waterproof rating
Flush test device		IPX5、IPX6

Spraying aperture	ø6.3mm & ø12.5mm
water spray pressure	30kpa and 100kpa (reference value, subject to flow rate)
water spray	12.5±0.625L/min vs. 100±5L/min
Test time	Minimum 3min
Structure of the test device		By the water storage tank, pressurized water pump, regulating and reducing valve, flow regulator, pressure gauge, water pipe Diversion device and spray bracket (shared with the sprinkler rosette device) electrical control box and other components
water-storage tank		Made of thickened high-grade brushed stainless steel with argon arc welding.
Spray bracket		Made of stainless steel finishing
security protection		Overall equipment under-phase/reverse-phase, test timing, leakage protection, short-circuit protection
Supply Voltage		AC380V±10% 50Hz
Note: 1、according to the user’s specific test requirements non-standard customized nozzle splash test device, etc. 2、This technical information, if there is any change without prior notice

Industry News

Humidification Methods for Constant Temperature and Humidity Test Chambers

The humidification process in a constant temperature and humidity test chamber essentially involves increasing the water vapor partial pressure. The initial humidification method was to spray water onto the chamber walls and control the water temperature to regulate the saturation pressure of the water surface.

Solutions for Excessive Temperature Fluctuations in High and Low Temperature Test Chambers

After putting a high and low temperature test chamber into operation, is it normal for the equipment to exhibit significant temperature fluctuations? This may indicate a malfunction, requiring prompt troubleshooting and resolution.

How to Clean the Water System of a High-Low Temperature and Humidity Test Chamber

After long-term use, components or systems of a high-low temperature and humidity test chamber may encounter certain issues.