Search for the product you are looking for
Walk-in Rain Test Chamber

Walk-in Rain Test Chamber

Product Introduction
walk-in rain test chamber is suitable for testing the waterproof sealing of outdoor motorized trains. Through the waterproof test chamber, the water sealing status of motorized trains is confirmed by making the conditions of the rain test similar to the natural state outside, and structural improvements are made to the parts that may leak rain.

Service Hotline

4000-662-888
Product Features
Product Parameter
Studio Size  (D*W*H)mm 7000×4000×4000(D*W*H)mm
Hole Diameter Φ2.5—3.0mm
spraying density 550×550mm
water jet pressure 150±10KPa
Sprinkler Pipe Diameter Depending on the flow rate
Pressure Class 1.5 accuracy manometer, dial #100, 0 to 6kg/cm², with pressure sensor
flow meter Electromagnetic flow meter
rain gauge Depending on the flow rate
standard configuration Water pumps, sewage pumps, filters
shower duration Arbitrary Adjustment
Supply Voltage AC380V±10% 50Hz
Upper front enclosure 6mm±1mm/min
Side & Top 8mm±1mm /min
other One IPX5, one IPX6 printhead each
Note:
1、 the above data are in the use of ambient temperature of 25 ℃ and well ventilated conditions measured
2、Can be customized according to the specific requirements of the user non-standard Walk-in rain test chamber etc
3、This technical information, if there is any change without prior notice

 

Product Recommendation
Industry News
Cold and hot shock test chambers utilize high-temperature and low-temperature zones during testing. In the testing process, two-box models involve placing the test product in high and low-temperature zones for cyclic exposure, while three-box models involve blowing high- and low-temperature gases onto the product alternately.
After putting a high and low temperature test chamber into operation, is it normal for the equipment to exhibit significant temperature fluctuations? This may indicate a malfunction, requiring prompt troubleshooting and resolution.
The salt spray test chamber is an essential testing device for evaluating the corrosion resistance of various materials. Depending on the material or product being tested, key parameters such as temperature, humidity, pH value, and solvent composition may vary.