Analysis of Fault Alarm Principles in Constant Temperature and Humidity Chambers

Source：LINPIN Time：2025-03-31 Category：Industry News

Analysis of Fault Alarm Principles in Constant Temperature and Humidity Chambers
Over-temperature Alarm in the Chamber: The sample area sensor and the channel are equipped with over-temperature protection devices. An over-temperature protection device is also installed on the control panel. If the temperature in the test area exceeds the allowable temperature set on the panel, the equipment will shut down and trigger an alarm. The TH setting must be at least 10°C higher than the operating temperature for the equipment to function.

Sample Over-temperature Protection: If the temperature in the sample area exceeds the protection temperature set by the controller, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and the system is reset. Sample over-temperature protection includes both upper and lower limits, which can be arbitrarily set by the user as needed.

Constant Temperature and Humidity Chambers

Fan Overheating Alarm: If the fan coil overheats, the equipment will shut down and alarm. Operation can only resume after the fault is resolved.

Fan Overcurrent Alarm: If the fan current exceeds the allowable value, the equipment will shut down and alarm. Normal operation can only resume after the overcurrent fault is repaired.

Cooling Water Shortage Alarm: If the water pressure in the cooling circulation system is insufficient, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and the system is reset.

Refrigeration Compressor Overheating Alarm: If the compressor coil overheats or the circuit power supply is abnormal, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved.

Refrigeration Compressor Overpressure Alarm: If the refrigerant pressure in the refrigeration system exceeds the set value, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved and manually reset.

Power Phase Loss or Phase Sequence Alarm: If the external power supply experiences phase loss or phase sequence reversal, the equipment will shut down and alarm. Normal operation can only resume after the fault is resolved.

Previous article: Constant Temperature and Humidity Test Chamber Detailed Introduction

Next article: How to Keep an Aging Test Chamber in Optimal Condition?

News Recommendation

25.04

Formaldehyde VOC environmental test chamber: Here’s What You Need to Know About Its Structure!

The formaldehyde VOC environmental test chamber is primarily used to detect formaldehyde content in building materials, artificial panels, curtains, carpets, and other products.

25.05

Requirements for Wind Speed During the Operation of Dust and Sand Test Chambers

Adjusting the wind speed is crucial for dust and sand test chambers, as it directly affects the test results of the specimens. What are the specific requirements for wind speed during the operation of these chambers? Today, let's delve into the details together.

25.04

Xenon Lamp Aging Test Chamber Selection Guide – Simplified & Easy to Understand

A xenon lamp aging test chamber is used to simulate natural environmental conditions such as sunlight, rain, and biodegradation, which continuously degrade products. To ensure product durability, this equipment artificially replicates these conditions to test whether the product meets quality standards.

25.05

Don’t Underestimate the Cleaning of High and Low-Temperature Test Chambers

Some may consider the cleaning of high and low-temperature test chambers a minor issue and not take it seriously. However, proper cleaning can improve equipment efficiency, reduce failure rates, and lower operational costs. This article emphasizes the importance of this task and provides a brief guide on cleaning procedures.

25.04

What to Do When the Circulating Water Pressure in a Thermal Shock Test Chamber is Insufficient?

If you find that the circulating water pressure in your thermal shock test chamber is insufficient, how should you resolve it? To address the issue at its root and prevent recurrence, we need to promptly identify and troubleshoot the problem based on the actual situation.