Thermal vacuum chamber-Linpin Instruments

Product Parameter

Basic Specification
Vacuum tank size	Inner diameter of vessel ≥φ1400×mm，length of straight section ≥1200 mm
Heat sink dimensions	φ1200×φ1200mm
Heat Sink Temperature Range	-70℃～100℃（Heat sink interior）
Heat Sink Temperature Control Precision	±2.0℃（Heat sink interior）
Limit Pressure	surpass 1×10-4Pa（+30℃）
Working Pressure	surpass 1.3×10-3Pa
Outer case material	High quality A3 steel plate electrostatic spraying
Inner box material	Imported high grade stainless steel SUS304
Temperature sensor	PT100 Platinum resistance thermometer
Pressure sensor	Electronic Pressure Transmitter
controller	Imported “UMC” brand temperature meters
Cooling method	Two-machine cascade cooling
Safety	Compressor overpressure overload, fan motor overheating, overall equipment under phase/reverse phase, over temperature, overall equipment timing, leakage protection, overload and short circuit protection
Supply Voltage	AC380V±10% 50Hz
Power	Mainframe about 50KW
Operating environment	+5～+35℃、≤85%R.H
Note: The above data are all measured under well ventilated conditions at an ambient temperature of 25℃: 1、 the above data are in the use of ambient temperature of 25 ℃ and well ventilated conditions measured 2、Can be customized according to the user’s specific test requirements of ice-covered test chamber, ice-covered test chamber, etc. 3、This technical information, subject to change without notice

Industry News

How to Determine Whether the Compressor in a High-Low Temperature Alternating Test Chamber is Good or Bad

The performance of the compressor in a high-low temperature alternating test chamber directly affects the efficiency of the equipment and the test results. Therefore, customers should choose a high-quality compressor to enhance the device's performance. So, how can you determine whether the compressor in the test equipment is good or bad?

Price vs. Quality: Which Matters More When Choosing a Temperature Cycling Test Chamber?

When purchasing a temperature cycling test chamber, customers must weigh multiple factors, including price, quality, accuracy, and efficiency. Among these, the debate between prioritizing price or quality is particularly common.

Standardized Operating Instruction for Constant Temperature and Humidity Test Chambers (Applicable to R&D, Quality Inspection, and Third-Party Laboratories)

To ensure the electrical, mechanical and thermodynamic integrity of constant temperature and humidity test chambers (hereafter “the chamber”), to standardize operating procedures, and to reduce failure and accident rates, this instruction is established. It applies to all programmable, single-point and walk-in chambers that are newly purchased, in service or relocated.