Constant temperature water immersion test chamber-Linpin Instruments

Product Parameter

Model	LRHS-55-LJS
Studio Size (DWH)mm	380×580×250（DWH）mm
operating temperature	40℃±1℃(user requirements)
deionized water	Conductivity＜2×105Ω/cm
Case Material	Corrosion-resistant, high-strength, anti-aging, high-temperature resistant PP reinforced rigid plastic sheet
Lid Material	Corrosion-resistant, high-strength, anti-aging, high-temperature resistant PP reinforced rigid plastic sheet
Temperature Controller	Korea Saintyear ST190 Meter
temperature sensor	PT100 platinum resistance temperature measurement body
heaters	Stainless steel electric heaters
interrupter	Schneider miniature circuit breakers (to prevent short circuits in control circuits)
standard configuration		Deionized water tank
security protection		Over temperature, end of test, low water level protection, leakage, short circuit
Supply Voltage		AC220V±10% 50Hz
Power consumption		2.5kW
operating environment		5℃～＋40℃ ≤85% RH
Note: 1、the test data are used in the ambient temperature of 25 ℃ and well ventilated conditions measured 2、Can be customized according to the specific requirements of the user non-standard constant temperature water immersion test chamber etc 3、This technical information, subject to change without notice

Industry News

What Difficulties May Be Encountered During Rain Spray Chamber Testing?

Rain spray chambers are commonly referred to as waterpr […]

Safety Precautions for Using High and Low Temperature Shock Test Chambers

Safety always serves as the cornerstone of equipment operation, and for specialized equipment like high and low temperature shock test chambers, safety considerations are of utmost importance. Below, we will elaborate on the key safety points that require special attention during the use of high and low temperature shock test chambers.

Technical Guidelines for Safe Operation and Standardized Use of Low Temperature Test Chambers

Low temperature test chambers serve as critical equipment for material low-temperature performance verification, electronic component reliability testing, and biological sample preservation.